What You'll Need ;
Fabric (about 2 yards of 3" wide)
Scissors or/and rotary cutter, pins, ruler
I started with an old sash, If you don't have one, the length was about 2 yards and 3 inches thick. (enough to fit the iron-on letters) I traced the sash and doubled my fabric, then cut it out. *I have also seen ribbon being used too*
This is what the old sash looked like.
My two layers of fabric
Tracing both ends and making the whole thing about 3 inches wide for the iron-on letters to fit properly.
Cut out on the lines.
After cutting it out, I sewed the two pieces right sides together at the very top. NOW it will start looking like a real sash!
Next I turned it back to the stitch was on the inside not showing. Iron on the letters that you want, using the instructions of the Iron-On letters.
I used BRIDE.
Now pin, tie it up or you can even sew the bottom together and you have finished your project!!
.......please excuse my nails :|
BUT NOW YOUR DONE!
Now enjoy your night ladies!!!
Check out how to make your very own "Oh SH*T" hangover kit too !!
Keep up with me & Let me know your here!